use this wisely... trunks pass all vlan traffic by default... and that is good...
dls1(config-if)#sw trunk ?
allowed Set allowed VLAN characteristics when interface is in trunking
mode
encapsulation Set trunking encapsulation when interface is in trunking mode
native Set trunking native characteristics when interface is in
trunking mode
pruning Set pruning VLAN characteristics when interface is in trunking
mode
dls1(config-if)#sw trunk allowed vlan except ?
WORD VLAN IDs of disallowed VLANS when this port is in trunking mode
dls1(config-if)#sw trunk allowed vlan except
can't say it better than the above output...
network cisco ccna gns3 certification arteq
a network runs through it
No comments:
Post a Comment